How long does it take to install the ocean clipper?
The Ocean Liberator CNC Beam Coping Machine can
be installed and operational in your facility less than 3 days
after receiving the machine. The machine is simple to install
and most of the work is done by the customer prior to the
service technician arriving at the customer's facility.
Prior to installing your machine you will need
to supply the following
-
Flat and level concrete pad 4" thick (or
more)
-
Dry shop air at 90-125 psi
-
Electrical power to run the machine. Note
that the
Ocean Clipper requires 3-phase 480V power supply. If you do
not have 480V power Ocean machinery can supply you with a transformer to convert any 3-phase
source voltage including 208/22, 380, 400 and 560V to the
native 480V required by the angle line.
-
Optional Cat5 Network Cable for direct
downloading of your detailing files to the programming
pedestal.
-
Hydraulic oil for the hydraulic system
The machine arrives by standard freight carrier. You,
the client, are responsible for offloading the
Ocean Clipper from the transport truck and setting up the
machine in his facility.
What training is provided for this CNC beam coping machine?
Once you have notified Peddinghaus that ll the
pre-installation work has been completed, and you have faxed the
Installation Readiness form to Peddinghaus, then the Peddinghaus service technician will
travel to your facility
and do the final setup and calibration of your machine, and then
spend time with your operators taking them through our simple yet
thorough training program.
Your operators will receive training in
-
machine setup and adjustment
-
machine maintenance and lubrication
-
fault finding and troubleshooting
-
programming of parts using Peddimat
-
importing of parts using Peddimat
-
How to change our punches and dies
-
how to sharpen your drill bits
What software training do I receive?
The Ocean Clipper uses the industry standard
Peddimat software, so importing part programs directly from your
steel detailing software to the Ocean Clipper angle lines is a
simple process, as long as your steel detailing software
supports the DSTV file output standard.
Your installation technician will show you how
easy it is to program parts into the Ocean Clipper using the
Peddimat software, both at the machine and offline in your
office.
You will also be shown how to import CAD
detailed files (that support the DSTV format) directly into your
machine completely eliminating any possibility of operator
error.
We are also able to offer operator training
courses and for new operators (and refresher courses for
existing operators at the Peddinghaus facility in Bradley
Illinois - please call for details and pricing |
